Adapter Plates
for D-LIGHTZ and

This adapter plate is designed to allow the following LED Downlight products to be retrofitted in place of an old style recessed luminaire:

  • D-LIGHTZ Tilt
  • E-LIGHTZ Mini
  • E-LIGHTZ Mini Low Power

The outside diameter of this adapter plate is either Ø130mm or Ø155mm, therefore you will be able to install any of the above products with the adapter plate into an approx. 100-140mm cutout. Simply remove the entire old light fitting and install the product complete with adapter plate. Once installed you are then able to pack insulation completely around the product.

The E-LIGHTZ Mini and D-LIGHTZ products all share the same trim profile allowing them to be used in the same lighting scheme. Three trim colours available.

DimensionsØ 130 mmØ 155 mm
Cut-outØ 100 mm - Ø 115mmØ 100 mm - Ø 140mm
D-LIGHTZ Tilt Spec Sheet E-LIGHTZ Mini Spec Sheet